Installation Steps
1. Insert the conductor and the wedge end into the groove until to the marking line.
2. Put The clamp on the gun seat and locate it, with wire thread insert. Make sure the end of the gun tightly top the wedge.
3. Remove the back cover of the gun and load the bullet core. Then install the back cover and tighten it.
4. Pull the rear cable to the right place and press the button. Bullet core firing,The push rod will push the wedge core into the
inner of the clamp
5. Remove the ejection gun and unscrew the rear cover, taking the bullet core out. Clean the inner and outer suface of the
tools, with prevention oil and put in the tool case.
Previous:copper bolt shear bolt lug copper mechanical lugNext:OEM/ODM Factory China 2 Pole 16-95mm2 Ce&RoHS Certification Copper to Aluminum Connectors 245A 750V Aluminum Connectors
tel
+86-13738313195